Working please wait updating ai

Everytime an opponent talks to me the game hangs trying to load that 3d model and stuff." Pretty much spot on, happened in another Civ type game I play, Star Trek Birth of the Federation.

Only difference between me and you is that my turns take 40 seconds and I have a Q6600 2.40ghz processor and your cpu dwarfs mine.

You should receive a “OK” message.9) Close Termite.10) Next, follow this project () to upload software from Arduino IDE to your ESP8266 module.

TX/RX pins are used to program this module, for serial I/O, and debugging (but I’m not confidence about other alternatives instead serial monitor).

When I flash the ESP8266 it is need to use GPIO0 in GND to put this module in programming model.

Softwares:- FLASH_DOWNLOAD_TOOLS_v2.4_150924- AT_v0.51_on_ESP8266_NONOS_SDK_V1.5.0- Termite (Serial monitor), or pu TTY.1) Make the wiring of your ESP8266 module as illustrate in figure.2) Open the FLASH_DOWNLOAD_TOOLS_v2.4_150924/ESP_DOWNLOAD_TOOL_V2.4 Just click over START button, but uncheck the download path config checkboxes.

DETECT INFO and MAC Address areas should display ESP8266 information.3) Now, check the path boxes as follow, as illustrated in figure:* AT_v0.51_on_ESP8266_NONOS_SDK_V1.5.0\at\esp_init_data_-- 0x000004) Click START and wait SYNC until complete flash of firmware files.5) Close FLASH_DOWNLOAD_TOOLS_v2.4_150924/ESP_DOWNLOAD_TOOL_V2.4 Set your COM number and 115200 baud rate value.6) Disconnect only the GND wire whilst Termite is open, and reconnect GND.

Search for working please wait updating ai:

working please wait updating ai-58

Yep this happens to about everyone at some point in a 12-player match-up. I heard some people say it runs quicker again after reloading saves.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “working please wait updating ai”